Location:Home  >  Support
Correct switching process of water cooling system laser marking machine
DATE:2022/3/16 15:51:35  Page view:4248

The cooling methods of laser marking machines with high laser power are all water-cooled. For the equipment of the water cooling system, if the switching process is incorrect, it will cause the phenomenon of no light during marking, and in severe cases, the laser will be burned out. The laser is the core component, and the price is not cheap. Therefore, the correct switching sequence is particularly important.

Next, Foshan Fulan Laser will tell you about the correct switching sequence of the laser marking machine of the water cooling system:

Power on:

1. Plug in

2. Turn on the main switch (pull up)

3, mention "emergency stop"

4. Press "Industrial Control"

5. Turn on the chiller (the key and laser power can only be turned on when the water temperature of the water tank reaches 25°C)

6. Open the "key" (hit horizontally)

7. Turn on "Laser"

8. Remove the lens cap

9. Open the marking software


Shutdown:

1. Close the marking software

2. Turn off "Laser"

3. Turn off the "key" (play vertically)

4. Turn off "Industrial Control" (computer)

5. Turn off the main switch (pull down)

6. Turn off the "chiller" (Note: After turning off the power of the laser marking machine, it is necessary to keep the chiller on for about 3 minutes, and the chiller can be turned off after the compressor of the laser water cooling system stops).

7. Unplug

8. After 5 minutes of shutdown, cover the lens with the cover




Online

Online

Tel

Manager Wen: 18902563402

QQ

QQ/p>

Wechat

Scan and follow
Fulan Public Account

Back
Top